fischer MU M12 DIN 985 A2

The adjustable and convenient system for installing photovoltaic systems on industrial roofs with concrete tiles and domes.

Advantages

It does not require replacing the fairing. Solar-Y mounts on beams without removing the cover
Make the most of panel efficiency with angles up to 25° tilt, with verifiable sizing
Fully adjustable. The bases adapt to all shapes of beams and the inclination of the panels is continuously adjustable. One product for all construction sites
Verifiable sizing with snow and wind loads by regulations throughout Italy
Cost-effective, optimized structure increases pitch between triangles while minimizing the number of structures and fixings
Configurable with South or East-West orientation.

Solar-Y allows you to fix photovoltaic systems on warehouses and commercial buildings with structure in reinforced concrete beams and roof in domes. The system does not require dismantling the screens, allowing you to install panels with angles up to 25 ° to get the best output of the panels and can be sized with snow and wind loads by legislation.

Properties

Profiles: Aluminium EN AW 6063 T6
Strut:Aluminium EN AW 6060 T6
Brackets: Aluminium EN AW 5754 H22
Spacer: Aluminium EN AW 6026
Hinge:Aluminium EN AW 5754 H22
Screws and nuts: Stainless Steel A2 R70

Functionality

Configure the system based on the orientation and span of the beams and the angle of the photovoltaic panels. Follow project specifications and quantities for all installation phases.
Assemble the bases.
For the SUD variant, assemble the triangles by joining 1 Solar-Y Profile and 1 strut with the appropriate hinges.
Adjust the distance of the hinges from the end of the Solar-Y Profile.
For the EAST-WEST variant, use 2 Solar-Y Profile (cut to size).
Place and fix the brackets on the concrete tiles.
Assemble the triangles to the brackets fixed on the beams through the M12 screws and nuts.
Bracing the triangular structures at the ends of each group of panels using the BP AL profile using the self-drilling screw fischer T.E. 4.8x32 mm as fastening.
If necessary, mount the secondary profile warp above the triangles through the PXC-AL joints.
Place the photovoltaic panels on the structure and lock them with the fischer terminals.

Mounting Strip 1 Picture

1 / 10

Mounting Strip 2 Picture

1 / 10

fischer MU M12 DIN 985 A2

Prednosti / Opis proizvoda

Uputstvo za montažu

Tehnički Podaci

Dokumenti za preuzimanje

Amount	200 pcs
GTIN (EAN-Code)	8001132110768